What does code P0313 mean?

Misfire Detected With Low Fuel
OBD-II Code P0313 is defined as a Misfire Detected With Low Fuel. When the engine control module (PCM) detects that one or more cylinders are not sufficiently contributing to keeping the engine running properly, it will set code P0313.

Can low fuel cause misfire?

If you pulled codes from the vehicle that indicated a misfire, a lack of fuel supply may be to blame. The vehicle then decides how much fuel needs to be mixed with the amount of air being sent in. If the fuel pump cannot keep up with the amount of air, misfires occur, and stalling is a possibility.

How do I fix my BMW P1345 code?

P1345 Faulty Plug, Coil, or Injector

  1. Swap ignition coil #2 with the ignition coil from another cylinder.
  2. Drive for a little and see if the misfire follows to the new cylinder.
  3. If not, swap spark plug #2 with a spark plug from another cylinder.
  4. Drive and check if the misfire follows to the new cylinder.

What causes code P0316?

Code P0316 is triggered when your Engine Control Module (ECM) detects that the position of either your vehicle’s crankshaft or camshaft is outside of its parameters, which can lead to an engine misfire upon starting. If any on these are outside of their designated parameters, the engine will misfire.

What happens if ignition coil goes bad?

One of the most common symptoms associated with a faulty ignition coil is engine performance issues. Faulty coils may cause the vehicle to experience misfires, a rough idle, a loss in power and acceleration, and a reduction in gas mileage. In some cases the performance issues may even result in the vehicle stalling.

What does Engine code P1345 mean?

Error Code P1345 is defined as Crankshaft Position-Camshaft Position Correlation. This error code is a manufacturer-specific trouble code, meaning it does not apply to all vehicles makes. Rather, it applies only to specific vehicle makes, such as Audi, GM (Chevrolet/GMC), Isuzu, Lexus, Mazda, Toyota, and Volkswagen.

What does the p0313 code on a BMW mean?

P0313 BMW Meaning The Engine Control Module ( ECM ) monitors the fuel level. This Diagnostic Trouble Code (DTC) is stored when a misfire is detected and the fuel level is below 15% of the fuel tank capacity.

What causes a misfire on a p0313 engine?

Common mistakes when diagnosing the P0313 code. The most common mistake when diagnosing P0313 is neglecting to fill the fuel tank first. In many instances, the cause is because of poor fuel flow to the engine because of low fuel level. Otherwise, misdiagnosis can occur if parts are replaced before a thorough diagnosis is performed.

What to do if DTC p0313 has low fuel level?

The common repairs for DTC P0313 are as such: Refuel the fuel tank. If the concern is due to low fuel level, symptoms will then disappear, then the DTC will simply need to be cleared. Replace an ignition coil or ignition cables. Once the particular component has been isolated, it can be replaced with a new one. Clean the fuel injectors.

What should I do if I have a p0103 code?

P0103 Mass or Volume Air Flow Circuit High Input Repair any additional code (s) and retest by clearing the code with the scanner and test driving the vehicle. If no supporting codes are present, then start with the fuel filter. The following diagnosis and repair procedures require a few special tools: