How tight should a spindle nut be?

The nut on the spindle should be tightened until snug, with no side-to-side play in the hub and then backed off slightly, about maybe a 1/8 of a turn. If the spindle uses a castle nut and cotter pin or tang nut, tighten the nut finger tight until it

What size is the spindle nut?

The thread diameter of spindle jam nut #6-191 is 1 inch. If you do need a 3/4 inch then this nut will not work, though it is for EZ lube spindles that have the grease zerk at the end.

What is a spindle nut used for?

A spindle nut is threaded onto the spindle to affix the hub assembly onto the spindle. The spindle nut performs the critical function of retaining the hub assembly on the spindle. A novel spindle nut assembly is presented comprising three components: a locking washer, a locking snap ring, and a nut.

What is a hub nut?

Hub nuts are responsible for keeping the driveshaft within the wheel hub on front-wheel or 4×4 vehicles. If you need to replace the hexagonal nuts on your car, simply enter your registration details here and find your perfect fit. The hub nut is a crucial part of what gives you drive in your car.

How tight should a trailer spindle nut be?

The nut on the spindle should be tightened until snug, with no side-to-side play in the hub and then backed off slightly, about maybe a 1/8 of a turn. If the spindle uses a castle nut and cotter pin or tang nut, tighten the nut finger tight until it…

How do you remove a spindle nut?

6:33Suggested clip 111 secondsHow to Remove Axle Nut on Honda – Rusted Stuck Axle Nut will not …YouTubeStart of suggested clipEnd of suggested clip

How do I know if my trailer bearings are bad?

If noise is heard, check for a bad bearing or if lubrication is needed. Check for Heat – Tow the trailer for a short distance, 5-10 miles at highways speeds, then park the trailer. Place your hand on each of the wheel hubs of the trailer. If it is too warm to hold your hand in place, you may have a bad bearing.