How do you check the check engine light on a Dodge Ram 1500?

Check Your Gas Cap. This is the most common reason a check engine light comes on. It’s an easy fix, too. Simply access the gas cap, remove it, and replace it. Then make sure it’s seated in place.

How can I check my engine code without a code reader?

Flip your car’s ignition on and off a couple of times without cranking the engine and finish with the key in the on position. Your car will then check for any saved trouble codes. All the lights on the dash should light up until one remains on—usually the “service engine” light.

How do you clear the codes on a Dodge Ram 1500?

How To Reset the Check Engine Light on a RAM 1500

  1. Find your battery under the hood and disconnect the black/negative cable.
  2. Wait 20 minutes for the power reserve to expire. The RAM 1500 check engine light should reset automatically during this time.
  3. Now, just reconnect the black/negative cable.

How do you reset the check engine light on a Dodge Ram 1500?

Why is my check engine light on Dodge Ram 1500?

What could cause the check engine light to come on in a Ram 1500? When your check engine light comes on, this could be as simple as tightening or replacing your gas cap. One of the most normal and many cause is that your Ram 1500 gas cap is loose, damaged or missing.

How do I display check engine codes?

Inserting and Reading an OBD Scanner

  1. Step 1: Locate your vehicle’s OBD port.
  2. Step 2: Plug your OBD scan tool into the connector.
  3. Step 3: Read the codes in the computer.
  4. Step 4: Record the codes that display.
  5. Step 1: Break down your code into sections.
  6. The first section is the first character, which is always a letter.

How do I check and get engine codes?

Inserting and Reading an OBD Scanner Locate your vehicle’s OBD port. The most common mounting location for an OBD port is under the driver’s side of the dash near the pedals. Plug your OBD scan tool into the connector. The scan tool’s male end will only fit one way onto the vehicle’s connector. Read the codes in the computer. Record the codes that display.

How do you read Check Engine codes?

Reading your vehicle’s check engine codes is as easy as plugging in a code reader to the OBD II diagnostic port, which is typically located on the driver’s side, under the steering wheel. Once the code reader is connected, it will display what code(s) are being triggered by the vehicle’s ECU.

What does a Dodge Ram p0601 code mean?

In Dodge/Chrysler products, a P0601 trouble code means that a serial communication failed inside the computer at least 6 times. Other internal control module error trouble codes include: P0602 Control Module Programming Error; P0603 Internal Control Module Keep Alive Memory (KAM) Error; P0604 Internal Control Module Random Access Memory (RAM) Error

How do you reset check engine light on Dodge Journey?

You can reset the light in a few minutes manually from home using a simple tool purchased from your local auto parts store. Or most auto parts stores will reset it for you for free. Locate and open the fuse panel cover on your Dodge. This is inside the vehicle on the bottom of the dashboard on the driver’s side.