How do I reset my Cisco 3750x to factory settings?

First you need to power down the switch. Once the switch is powered off, hold down the mode button, and power the switch on. The switch will boot up and you should see the switch prompt as shown below. flashfs[0]: flashfs fsck took 11 seconds.

How to reset catalyst 3750 password?

Password Recovery – Reset Procedure

  1. On a 3750-X switch, Power off the entire stack or standalone switch.
  2. Reconnect the power to the switch (standalone 3750-X or 3750-X) or stack master (3750-X stack only).
  3. Now initialize the flash file system, rename the startup configuration file (config.text) and boot the IOS:

How do I reset my 3560x?

Cisco 3560-X Password Reset

  1. Unplug Cisco 3560-X power.
  2. Hold down “Mode” button on front, and plug in power.
  3. Continue to hold “Mode” for about 15 seconds, until the SYST LED turns solid green, then release.
  4. Log into the switch via console, you should see the “switch:” prompt.
  5. Enter the command flash_init.

How do I reset my Cisco switch password?

Here is an easy way to physically perform a password recovery on a Cisco Catalyst Switch. Step 1: Connect your PC or terminal into the switch console port with the blue console cable. Step 2: Open up a Hyperterminal for emulation and set the speed to 9600 baud. Step 3: Unplug the power cable to the switch.

Whose trunk encapsulation is auto can not be configured to trunk mode?

IOS : An interface whose trunk encapsulation is “Auto” can not be configured to “trunk” mode. Command rejected: An interface whose trunk encapsulation is “Auto” can not be configured to “trunk” mode. This is because you are missing the encapsulation type (likely to be 802.1Q) on that port.

Do you need network modules for a 3750x?

When you order a 3750X, it does not come with any network modules. If you are planning to connect them using 10Gig ports, you need to order this part number in addition to your switch You also need to order the correct optics. If your distance is short you need Multimode SFP+ if your distance is not short you need Single mode SFP+ optics.

Is the 3750g compatible with 10 Gbps?

3750G will NOT support 10 Gbps. 10 Gbps is supported on the “E” or “X” models. 04-30-2013 02:53 PM 04-30-2013 02:53 PM Thanks Leo for pointing this out. I thought both stacks were 3750X. You can only connect these stacks using 1Gig. Form the data sheet I provided above, order the Gig module with 3750X and Gig SFP. Ignore the 10Gig section.

How many GBE does a Cisco Catalyst 3750-X have?

Figure 4 shows various Network Modules with Four GbE, Two 10GbE SFP+ Interfaces, Two 10GB-T and Service Module with Two 10GbE SFP+ Interfaces. Figure 4. Network Modules with Four GbE, Two 10GbE SFP+ Interfaces, Two 10GB-T and Service Module with Two 10GbE SFP+ Interfaces

How many uplink ports does Cisco 3750-X series Switch support?

The Cisco Catalyst 3750-X Series and 3560-X Series Switches support four optional network modules for uplink ports. The default switch configuration doesn’t include the uplink module; at the time of switch purchase the customer has the flexibility to choose from the network modules described in Table 3.