What is a common path of egress travel?
The “common path of egress travel” is defined as “that portion of the exit access travel distance measured from the most remote point within a story to the point where the occupants have separate and distinct access to two exits or exit access doorways”.
What size room requires 2 exits?
Two exit access doorways are required in boiler, incinerator and furnace rooms where the area is over 500 square feet (46 m2) and any fuel-fired equipment exceeds 400,000 British thermal units (Btu) (422 000 KJ) input capacity.
What is the maximum length of a corridor with a dead-end?
1.1, the length of the dead-end corridors shall not exceed 50 feet (15 240 mm). A dead-end corridor shall not be limited in length where the length of the dead-end corridor is less than 2.5 times the least width of the dead-end corridor.
What do you need to know about means of egress?
Key Takeaways In building code, a means of egress is a way to exit a property in the case of a fire or other emergency. Every apartment or other residence must have at least two means of egress. These can be door, windows, ramps, corridors, or fire escapes.
What are means of egress in second story apartment?
This is your first means of egress. Other means of egress for second-story apartments can include: In building code, a means of egress is a way to exit a property in the case of a fire or other emergency. Every apartment or other residence must have at least two means of egress. These can be door, windows, ramps, corridors, or fire escapes.
Can a person egress through an adjacent room?
However, in some cases such as an auditorium where people exit through a lobby, egress through an adjacent room (the lobby) will be acceptable. If there are questions regarding egress through adjacent areas, they should be brought to EHS’s attention for further evaluation.
How tall does a ceiling have to be to be a means of egress?
The means of egress shall have a ceiling height of not less than 7 feet 6 inches (2286 mm) above the finished floor. 1. Sloped ceilings in accordance with Section 1207.2.